Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Windsor, CT

CHI Overhead Doors Garage Door Roller Replacement in Windsor, CT

Worn steel or plastic rollers swapped for quiet, sealed nylon rollers. Typical cost $150-$350.

When your door needs CHI Overhead Doors garage door roller replacement, you want it done safely and right the first time. Typical jobs in Windsor, CT cost $150-$350, and you approve the price first. Worn steel or plastic rollers swapped for quiet, sealed nylon rollers. We work on CHI Overhead Doors garage doors of every age, from older models to current lines, and carry or can source compatible parts. CHI Overhead Doors builds residential and commercial sectional doors in Arthur, Illinois, and sells them through independent dealers.

When to call for CHI Overhead Doors garage door roller replacement

  • Grinding, squealing or rumbling as the door moves
  • The door shakes or jerks in the track
  • Cracked, chipped or wobbly rollers
  • Rollers that no longer spin freely

What usually causes it

  • Worn-out bearings in steel rollers
  • Cracked builder-grade plastic rollers
  • Rust or dust packed into the bearings

What you can check yourself

  • Watch the rollers while the door moves. They should roll, not slide.
  • Look for cracked plastic wheels or wobbling stems.
  • Leave the bottom rollers to a technician. They sit in brackets that hold cable tension.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

How we handle CHI Overhead Doors garage door roller replacement

  1. Inspect every roller, hinge and track section
  2. Replace rollers one hinge at a time, with sealed nylon rollers for a quieter door
  3. Replace the bottom rollers safely with tension controlled
  4. Lubricate hinges and bearings
  5. Test for smooth, quiet travel

CHI Overhead Doors Garage Door Roller Replacement cost in Windsor, CT

$150-$350Typical range, parts & labor
about 1 hourTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Other CHI Overhead Doors services

Serving Windsor, CT and nearby towns

With large seasonal temperature swings in Connecticut, track brackets and hinge screws work loose over time, and a loose track is the most common reason a door rubs, binds or comes off its rollers.

Close to the coast, salt air speeds up corrosion. Galvanized or coated springs, nylon rollers and stainless hardware hold up better than bare steel.

Technicians serve all of Windsor (ZIP codes 06006 and 06095), plus South Windsor (2.3 mi), Blue Hills (3.9 mi), Bloomfield (4.8 mi) and East Hartford (5.1 mi). Call (833) 435-8883 to book a visit in Windsor.

CHI Overhead Doors Garage Door Roller Replacement: frequently asked questions

How much does CHI Overhead Doors garage door roller replacement cost in Windsor, CT?

CHI Overhead Doors Garage Door Roller Replacement typically costs $150-$350 including parts and labor, and usually takes about 1 hour. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do CHI Overhead Doors garage door roller replacement the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is CHI Overhead Doors garage door roller replacement covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty, and CHI Overhead Doors warranty terms vary by product and age. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Connecticut or Windsor requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Windsor, CT

Hörmann Opener Gear & Sprocket Replacement

Stripped drive gears replaced so the motor moves the door again.

Typical $125-$275

Insulated Garage Door Installation

Polystyrene and polyurethane insulated doors that cut noise and temperature swings.

Typical $1,500-$5,000

Wayne Dalton Torsion Spring Replacement

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $200-$450

Richards-Wilcox Extension Spring Replacement

Side-mounted extension springs replaced in matched pairs, with safety cables installed.

Typical $150-$350

Allstar Remote & Keypad Programming

Allstar openers are no longer made. Replacement remotes and many parts are still available, and we'll tell you when replacing the opener makes more sense.

Typical $50-$150

Wayne Dalton Garage Door Panel Replacement

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $300-$900

Overhead Door Off-Track Garage Door Repair

Overhead Door traces its roots to C.G. Johnson, who invented the upward-acting garage door in 1921. The company builds residential and commercial doors and openers.

Typical $175-$450

Stanley Opener Gear & Sprocket Replacement

Stanley garage door openers are no longer made. Compatible remotes and some parts are still available for older units.

Typical $125-$275

Overhead Door Opener Circuit Board Replacement

Overhead Door-brand openers come from the same company as Genie, the Overhead Door Corporation.

Typical $175-$400

Rolling Steel Door Repair

Rolling steel service doors, curtains, guides and springs repaired.

Typical $300-$1,500

Overhead Door Garage Door Panel Replacement

Overhead Door traces its roots to C.G. Johnson, who invented the upward-acting garage door in 1921. The company builds residential and commercial doors and openers.

Typical $300-$900

Hörmann Extension Spring Replacement

Hörmann is a German manufacturer of residential and commercial doors and openers with North American operations.

Typical $150-$350

Garage door stuck, noisy or broken?

Talk to a garage door technician in Windsor, CT now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote